So what is Perf-X 3X ? Perf-X is a scratch built 3 axis CNC controller with two relay outputs, three home switch inputs and one pause. (EMS) Runs 5 to 6 volt 1 to 1.5 amp 6 wire UniPolar motors at 240 rpms (12 inches per minute with 1/4-20 threaded rod) with a 12 volt computer supply.
This is a cheap, simple UniPolar controller you can build. It is built by you using Perfboard and pretinned bus wire. The Perf-X booklet is a step by step guide to wiring your own controller.
|
Web Links
1. |
CNC Laser Cutting
... an E-stop to the Unversal Stepper Controller. The schematic of the custom electronics was generated ... lay over 100 feet of between the controller to the CNC table. Observe the loops of wire going ...
12-Jan-2006 Hits: 126 Rating: 0.00 Votes: 0
[Detail]
[Send URL]
|
2. |
100 Watt CNC Laser Installation
... report an E-stop to the Unversal Stepper Controller. The schematic of the custom electronics was generated ... components that will be used for the cnc laser. The laser has a power supply, a db-25 ...
12-Jan-2006 Hits: 124 Rating: 0.00 Votes: 0
[Detail]
[Send URL]
|
3. |
CNC
L6203 PCB schematic and overlays are now available here. I've finished the interface board ... Art Fenerty's Mach1 CNC controller program Dolphin CADCAM ShopCam Inc. for CNC router tables Peter ...
12-Jan-2006 Hits: 151 Rating: 0.00 Votes: 0
[Detail]
[Send URL]
|
5. |
3-Axis Stepper Controller
3-Axis Stepper Controller, schematic. ... For more info on homemade CNC equipment, see the series of articles by Dan Mauch starting in the October.
20-Jun-2006 Hits: 106 Rating: 0.00 Votes: 0
[Detail]
[Send URL]
|
|
|
